Macos server open directory6/10/2023 To restart the Grafana server, run the following commands: sudo systemctl restart grafana-server # namespace and thus CAP_NET_BIND_SERVICE has no effect. # A private user cannot have process capabilities on the host's user # Give the CAP_NET_BIND_SERVICE capabilityĬapabilityBoundingSet=CAP_NET_BIND_SERVICE To learn more about capabilities, refer to capabilities(7) - Linux manual page. # Alternatively, create a file in /etc/systemd/system//nfĪdd the following additional settings to grant the CAP_NET_BIND_SERVICE capability. Run the following command to create an override file in your configured editor. If you are using systemd and want to start Grafana on a port that is lower than 1024, you must add a systemd unit override. To configure the Grafana server to start at boot, run the following command: sudo systemctl enable rvice To verify that the service is running, run the following command: sudo systemctl status grafana-serverĬonfigure the Grafana server to start at boot using systemd To start the service, run the following commands: sudo systemctl daemon-reload Start the Grafana server with systemdĬomplete the following steps to start the Grafana server using systemd and verify that it is running: You should follow only one set of instructions, depending on how your machine is configured. The following subsections describe three methods of starting and restarting the Grafana server: with systemd, initd, or by directly running the binary. tar.gz file, then you execute the binary. deb package, then you can start the server using systemd or init.d. If you installed with the APT repository or. The following instructions start the grafana-server process as the grafana user, which was created during the package installation. For certain configuration changes, you might have to restart the Grafana server for them to take effect. This topic includes instructions for starting the Grafana server. Enterprise Open source Start the Grafana server
0 Comments
Leave a Reply. |